+ Reply to Thread
Results 1 to 2 of 2

Thread: Prism 2: Cracked Scrubber Cannister Lid

  1. #1
    RBW Member maxguru is an unknown quantity at this point maxguru's Avatar
    Join Date
    Sep 2009
    Location
    Huntsville, AL
    Posts
    54

    Prism 2: Cracked Scrubber Cannister Lid

    Hi,

    I managed to crack the lid on my Prism 2's scrubber cannister this weekend... long story.

    I have a spare cannister & lid, but since I've had a failure, I see an opportunity to engineer a better solution.

    What's the best material to machine a replacement lid from...
    Aluminum?
    Stainless?
    Delrin?

    Thanks,
    max

  2. #2
    Mature mouth breather silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running has a reputation beyond repute silent running's Avatar
    Join Date
    Jun 2005
    Location
    U.S.A. Brooklyn, New York
    Posts
    2,567
    Prism

    Dolphin

    Re: Prism 2: Cracked Scrubber Cannister Lid

    Quote Originally Posted by maxguru  View Original Post
    Hi,

    I managed to crack the lid on my Prism 2's scrubber cannister this weekend... long story.

    I have a spare cannister & lid, but since I've had a failure, I see an opportunity to engineer a better solution.

    What's the best material to machine a replacement lid from...
    Aluminum?
    Stainless?
    Delrin?

    Thanks,
    max
    Hi Max, from a thermal standpoint, the Delrin will hold heat longer than aluminum or stainless, as will any epoxy or plastic. Which is of course good for keeping the scrubber reaction going at max efficiency.

    Apparently Delrin does off gas, but there are different views on whether itís of any concern to CCR divers, who pass large volumes of gas around the loop and vent when ascending. This has been discussed before if you would like to check the rebreather world search function. I know there are manufacturers that stay away from Delrin, but I am not sure what they use whether itís some kind of resin or something else. I know the P1 is made of some type of resin, no Delrin on it... -Andy

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts