Can I get a close up photo of the cable going into the VR3 hand set?

**Monkey** · 15th August 2007, 19:09

Can I get a close up photo of the cable going into the VR3 hand set?

the fisher connector on my VR3 is crap... and I would like to see how the Ouroboros does it... So if I could impose for a good picture of the cable set up on the primary...

Thanks

Phil · 16th August 2007, 06:13

On the primary the cable goes in where the battery cap is on a VR3. The passive is a modified VR3 but the cable goes in via the normal I/O port. In both case they can not be detached from the unit. I am not sure if the part where the cable screws in was molded at the manufacturing time or if it is an add-on. Hope this helps!

**Monkey** · 16th August 2007, 14:20

Quote: (Originally Posted by Phil)

On the primary the cable goes in where the battery cap is on a VR3. The passive is a modified VR3 but the cable goes in via the normal I/O port. In both case they can not be detached from the unit. I am not sure if the part where the cable screws in was molded at the manufacturing time or if it is an add-on. Hope this helps!

Thank you very much.... this is exactly what I am looking for... I am going to see if Delta-P can modify my URM/ VR3 to use the same connector..

Fischer connectors are killing me

15th August 2007, 19:09	#1 (permalink)
Monkey Supporting Member Current Rebreather/s: Megalodon Other Rebreather/s: Join Date: Dec 2006 Location: Lauderdale By The Sea Florida Posts: 338	Can I get a close up photo of the cable going into the VR3 hand set? Can I get a close up photo of the cable going into the VR3 hand set? the fisher connector on my VR3 is crap... and I would like to see how the Ouroboros does it... So if I could impose for a good picture of the cable set up on the primary... Thanks
(Offline)

16th August 2007, 14:20	#3 (permalink)
Monkey Supporting Member Current Rebreather/s: Megalodon Other Rebreather/s: Join Date: Dec 2006 Location: Lauderdale By The Sea Florida Posts: 338	Re: Can I get a close up photo of the cable going into the VR3 hand set? Quote: (Originally Posted by Phil) On the primary the cable goes in where the battery cap is on a VR3. The passive is a modified VR3 but the cable goes in via the normal I/O port. In both case they can not be detached from the unit. I am not sure if the part where the cable screws in was molded at the manufacturing time or if it is an add-on. Hope this helps! Thank you very much.... this is exactly what I am looking for... I am going to see if Delta-P can modify my URM/ VR3 to use the same connector.. Fischer connectors are killing me
(Offline)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode