optima plastic premix rod

Tony_Q · 12th November 2007, 22:50

Hi Kathleen,

Thanks for the prompt response (very good customer service).

Regards,
Tony

dvrstev · 14th November 2007, 11:50

Kathleen,

I wasn't aware of Lamar's blog, thanks to you now I am. I'll be sure to check on it often. Is there any unique instruction for installing the quick disconnect tube? I have a the stainless steel tube version. I received the new tube from Dive Rite Express but haven't installed it yet because I wasn't sure if there was any special procedures.

Thanks
Steve

12th November 2007, 22:50	#21 (permalink)
Tony_Q New Member Current Rebreather/s: Optima Other Rebreather/s: Join Date: May 2005 Location: Australia Posts: 59	Re: optima plastic premix rod Hi Kathleen, Thanks for the prompt response (very good customer service). Regards, Tony
(Offline)

14th November 2007, 11:50	#22 (permalink)
dvrstev New Member Current Rebreather/s: Optima Other Rebreather/s: Join Date: Mar 2006 Location: California, Maryland Posts: 44	Re: optima plastic premix rod Kathleen, I wasn't aware of Lamar's blog, thanks to you now I am. I'll be sure to check on it often. Is there any unique instruction for installing the quick disconnect tube? I have a the stainless steel tube version. I received the new tube from Dive Rite Express but haven't installed it yet because I wasn't sure if there was any special procedures. Thanks Steve
(Offline)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode