PP02.com 3 display and sensor options

S. Marc · 8th October 2006, 17:56

Hi,

Does anyone know if you can use K1D sensors if there is a 10K load resistor installed on the Mark Munroe 3 display PP02 board that is currently running R22D sensors?

Thanks,

Marc

decoweenie · 8th October 2006, 18:05

I could be wrong, but I always thought the K1D and R22D are interchangeable as far as resistance load...

Simon A · 8th October 2006, 20:31

Marc,
It may work, but acording to the spec sheet I can find for the K1 requires a 180k load resistor, not the 10k the R22 requires.
HTH
Simon A

8th October 2006, 17:56	#1 (permalink)
S. Marc RBW Member Current Rebreather/s: Classic Kiss MK 15.X Other Rebreather/s: Not Bought Yet Join Date: Dec 2005 Posts: 204	PP02.com 3 display and sensor options Hi, Does anyone know if you can use K1D sensors if there is a 10K load resistor installed on the Mark Munroe 3 display PP02 board that is currently running R22D sensors? Thanks, Marc
(Offline)

8th October 2006, 18:05	#2 (permalink)
decoweenie Crash Test Dummy Current Rebreather/s: Other CCR Other Rebreather/s: Other CCR Join Date: Feb 2005 Location: Cairo Posts: 5,487	Re: PP02.com 3 display and sensor options I could be wrong, but I always thought the K1D and R22D are interchangeable as far as resistance load... __________________ "...after a while you get bored offering advice to a bull that like to keep butting the fence with its head rather than walking through the open gate..." - Rebreather World PM
(Offline)

8th October 2006, 20:31	#3 (permalink)
Simon A Escapee from DIY Rebreather's Current Rebreather/s: Inspiration Classic Other Rebreather/s: Not Bought Yet Join Date: Feb 2005 Location: Reading, UK Posts: 345	Re: PP02.com 3 display and sensor options Marc, It may work, but acording to the spec sheet I can find for the K1 requires a 180k load resistor, not the 10k the R22 requires. HTH Simon A
(Offline)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode