HH wet switches

***diverklondike*** · 26th May 2006, 02:15

I recently have switched from using the alarm mode to the PP02... I have found that my typical bottom PP02 of 1.2 is very easy to read and track..

Just my two cents..

M

Bazza · 26th May 2006, 08:04

Mark ... back to the original problem, the switching on of the unit.

Mate, lift off the new face plate and drill out the hole for the wet connector a few sizes ..... solves the tracking problem. Also check the pressure transducer hole below it for corrosion and again drill it out if blocked.

Works a treat ... regards Baz

26th May 2006, 02:15	#21 (permalink)
*diverklondike* Moderator Current Rebreather/s: Inspiration Classic Other CCR Other Rebreather/s: Inspiration Classic Other CCR Join Date: Oct 2005 Location: Delaware, USA Posts: 1,563	Re: HH wet switches I recently have switched from using the alarm mode to the PP02... I have found that my typical bottom PP02 of 1.2 is very easy to read and track.. Just my two cents.. M
(Online)

26th May 2006, 08:04	#22 (permalink)
Bazza New Member Current Rebreather/s: Inspiration Classic Inspiration Vision Evolution rEvo Other CCR Dolphin Other Rebreather/s: Prism Topaz Sport Kiss Classic Kiss MK 15.X rEvo Other CCR Dolphin Join Date: Feb 2005 Location: Australia Posts: 161	Re: HH wet switches Mark ... back to the original problem, the switching on of the unit. Mate, lift off the new face plate and drill out the hole for the wet connector a few sizes ..... solves the tracking problem. Also check the pressure transducer hole below it for corrosion and again drill it out if blocked. Works a treat ... regards Baz
(Offline)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode