+ Post New Thread
Page 11 of 33 FirstFirst ... 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 21 ... LastLast
Threads 201 to 220 of 656

Forum: New to Rebreathers

Home to that question you always wanted to ask. If your new to Rebreathers or want to find out more then head on in...

  1. Sticky Thread Sticky: Those confusing acronyms and abbreviations.

    We all use some of those dreaded acronyms and abbreviations - have you wondered what they were but did not want to ask? Well here all...

    Started by schford‎, 9th March 2005 16:28
    6 Pages
    1 2 3 4 5 ... 6
    • Replies: 55
    • Views: 19,434
    16th August 2010, 02:20 Go to last post
  2. Sticky Thread Sticky: Acronyms (consolidated list)

    7P's or PPPPPPP - Proper Planning and Preparation Prevents Piss Poor Performance AAS - Alternate Air Source ADV - Automatic Dilutant Valve...

    Started by cramerdn‎, 2nd October 2008 01:21
    2 Pages
    1 2
    • Replies: 10
    • Views: 8,439
    16th August 2010, 23:56 Go to last post
  3. Smile Sticky Thread Sticky: About This Forum

    We all started some where when it came to rebreathers and it can be a step change from open circuit. In the General Rebreather Articles section...

    Started by schford‎, 9th March 2005 16:08
    • Replies: 0
    • Views: 2,963
    9th March 2005, 16:08 Go to last post
  4. Exclamation Sticky Thread Sticky: Getting the most out of your Rebreather Questions

    I have had more than a few PMs and emails about how to get the most out of RBW with regards to specific questions about Rebreathers and I wanted to...

    Started by schford‎, 2nd December 2006 00:22
    • Replies: 2
    • Views: 2,486
    2nd December 2006, 13:08 Go to last post
  1. Flooded Scrubber

    Is wet scrubber material wasted scrubber material? If/when the loop/scrubber floods, can one dry the materiel out and re-use, or is it a total loss...

    Started by robertfondren‎, 21st October 2006 11:46
    • Replies: 6
    • Views: 2,031
    22nd October 2006, 08:50 Go to last post
  2. Hello from LI New York

    Hi all, I learned a bit abot rebreathers at the BTS show in New Jersey this weekend. Still confused on which one to buy. I do mostly North...

    Started by Mike Cupolo‎, 31st March 2008 17:51
    2 Pages
    1 2
    • Replies: 12
    • Views: 2,030
    2nd April 2008, 00:52 Go to last post
  3. missed deco??!!

    hi all help and advice please have just repacked scrubber and seyt up my inspo vision. after calibrating (which went as expected), i got...

    Started by ClarkKent‎, 28th September 2006 19:18
    • Replies: 4
    • Views: 2,023
    14th February 2007, 23:32 Go to last post
  4. What do you all think of a UBS 40 ?

    On the premiss that spending above 1500€ is out of the question, what do you all think of a UBS 40 ? I dive mostly fresh water lakes from 5-20m...

    Started by Mudfish‎, 17th November 2013 19:49
    2 Pages
    1 2
    • Replies: 14
    • Views: 2,017
    24th November 2013, 12:32 Go to last post
  5. Choices for New Training

    I am ready to become a rebreather diver and I have to chose a model to train on and buy. There are 3 instructors close to me that I could train with,...

    Started by Joe Cavallo‎, 6th May 2016 17:10
    • Replies: 7
    • Views: 2,011
    10th May 2016, 12:31 Go to last post
  6. Question The dreaded question?

    Hi.. let me spend five seconds telling you who I am. I'm 18 years old and I love diving UK style, and I;m taking the big leap. I now want to...

    Started by lost-diver@hotmail.co.uk‎, 17th November 2007 12:32
    • Replies: 9
    • Views: 2,007
    26th November 2007, 14:57 Go to last post
  7. Smile Maintainence Maunal for LAR V & LAR VI

    Hi Forum , i am new here , i am staying in SIngapore & will be very much appreicate that someone here could tell me where can i get the manual. thks...

    Started by Stealth‎, 1st August 2007 10:26
    • Replies: 2
    • Views: 2,000
    2nd August 2007, 06:09 Go to last post
  8. Question to all Meg Divers

    I'm about to order one but I'm still very unsure about the electronics. What are u guys using and why??? Thanks a lot, Patrick

    Started by Mephisto26‎, 26th June 2006 17:52
    • Replies: 8
    • Views: 1,994
    27th June 2006, 19:28 Go to last post
  9. Mass Flow

    Would a mass flow regulator set to deliver 100% o2 at .8lpm deliver the same number of molecules of oxygen as a MFR set to deliver 40% 02 @...

    Started by robertfondren‎, 15th November 2006 08:20
    • Replies: 7
    • Views: 1,976
    16th November 2006, 07:20 Go to last post
  10. The effect of bubbles on reef health...or lack there of

    I’m doing research on a vacation to Roatan...actually leaning toward Cayos Cochinos, a smaller archapellago MPA, because i have been reading about...

    Started by Gill Envy‎, 5th January 2006 22:42
    • Replies: 4
    • Views: 1,960
    21st February 2006, 02:22 Go to last post
  11. dolphin questions

    I would like to increase the buoyancy capabilities of my dreager dolphin whilst on the surface has any one adapted the dolphin to take another wing...

    Started by atty17‎, 28th May 2006 18:15
    • Replies: 8
    • Views: 1,946
    3rd August 2006, 20:48 Go to last post
  12. Choosing an Introduction to ________ CCR course

    Hello! I have a few questions and need some input on getting started. I am currently AOW, EANx certified, age 41, 944 logged minutes. I would...

    Started by Dawktah‎, 5th October 2006 02:45
    • Replies: 9
    • Views: 1,937
    6th October 2006, 20:45 Go to last post
  13. Bailout tanks, What size / brand / Construction

    Ok, I am now up to about 20hrs on my YBOD, very much a newbie and at the point I need to seriously think about my complete setup. My Diving...

    Started by Def‎, 25th July 2006 03:37
    • Replies: 6
    • Views: 1,936
    25th July 2006, 14:55 Go to last post
  14. OTS C/L and other stuff

    Greetings all, I'm gearing up for my first rebreather class (Meg) and after looking at/tearing down/reassembling a buddy's meg I have a couple...

    Started by trob09‎, 11th March 2005 13:12
    • Replies: 2
    • Views: 1,934
    11th March 2005, 15:05 Go to last post
  15. It's official, a new member to the family is on the way!

    It's now official, we have a little Gill JR on the way! My wife has decided to take a break from diving for a couple of years while she focuses on...

    Started by Gill Envy‎, 24th July 2008 17:18
    2 Pages
    1 2
    • Replies: 12
    • Views: 1,923
    26th July 2008, 07:44 Go to last post
  16. Maintaince - Ultrasonic Cleaner

    Gday Guys, I am just about to get a ultrasonic cleaner for my camera gear, and seeing my YBOD is about to leave the factory, I thought I better...

    Started by Def‎, 8th February 2006 05:15
    • Replies: 9
    • Views: 1,919
    8th February 2006, 13:58 Go to last post
  17. Cool WTD: Thoughts on advice on which to unit to choose...

    Hi, I have been diving open circuit for the last 10 years and have decided to take the plunge and move over to eCCR in Spring/Summer this year. ...

    Started by frank_the_tank‎, 9th January 2010 17:24
    2 Pages
    1 2
    • Replies: 14
    • Views: 1,919
    10th January 2010, 08:40 Go to last post
  18. rebreather ...piece by piece

    Hi everybody. I am new to rebreather (do not even have one). I was wondering if there's a thread here in the forum (or a website) where a rebreather...

    Started by granso‎, 19th May 2006 21:38
    • Replies: 5
    • Views: 1,917
    21st May 2006, 00:06 Go to last post
  19. Question CCR Electronic Controls?

    Hello everyone, Before I get into to this let me preface it by saying that my background is in mechanical and nuclear engineering. I can't...

    Started by navycurtissc‎, 31st August 2005 04:22
    • Replies: 1
    • Views: 1,909
    31st August 2005, 06:54 Go to last post
  20. kiss v sub

    Saying hello to everybody out there for the first time.......HELLO Now thats done down to business. Decided it was time for a new challenge and that...

    Started by andy d.‎, 1st April 2008 14:36
    • Replies: 8
    • Views: 1,909
    2nd April 2008, 15:24 Go to last post

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 50 replies or 1000 views
Hot thread with unread posts
More than 50 replies or 1000 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts