Rebreather World - View Single Post

PCDiver · 30th October 2006, 14:51

I agree with Mark for 100%. Before I installed the new battery caps and used the conductive grease, I ran into the same problem a couple of times (primary continously rebooting and injection O2).

A hard switch is an option, but not easy to implement. What I would like to see is that the no 02 is injected at startup if depth is below 6 meters. The other option could be for the primary to check whether a button was pressed continously (e.g. 3 seconds) at startup. If a button was pressed, the controller could go to inactive mode until another button is pressed. This could function as a soft "switch off" function.

30th October 2006, 14:51	#2 (permalink)
PCDiver Submerge Productions Current Rebreather/s: Inspiration Vision Other Rebreather/s: Inspiration Classic Join Date: Feb 2005 Location: Belgium Posts: 934	Re: Hard off switch on the Hammer Head I agree with Mark for 100%. Before I installed the new battery caps and used the conductive grease, I ran into the same problem a couple of times (primary continously rebooting and injection O2). A hard switch is an option, but not easy to implement. What I would like to see is that the no 02 is injected at startup if depth is below 6 meters. The other option could be for the primary to check whether a button was pressed continously (e.g. 3 seconds) at startup. If a button was pressed, the controller could go to inactive mode until another button is pressed. This could function as a soft "switch off" function.
(Offline)