Simon,
Quote: (Originally Posted by
Simon A)
Matthias,
If your inspo check valves are 26.7mm diameter then you should ring up AP and order some more. The current check valves are 31.2mm diameter and look much closer to the draeger check valves (they also breate a lot easier) I have an old one here with the 26.7mm measurement, but every set I've ordered in the last 3 years are the new style.
HTH
Simon A
Thanks, that helps a lot. Next stop is, fixing tha "missing Sensor II" problem.
Sensor is showing 12.3 mV output on air, so it is probably the Molex connector. I am very suspicious of the black centering piece. This could very well center the jack w/o making contakt to the pinholes. Will try to put some bias on the pins. Then lubricate every joint with "Wetprotect nautic".
Then isolate the cable glands leading throught the top from cold by some foam or delrin half-caps, to minimize inner condensation.
Matthias