| machining a pvc sensor holder
Hi all,
I am currently tryig to machine a sensor holder to be installed on my inhalation hose.
as the internal diameter of the pcv tube fitting I used is 63 mm I had to bore the tube internally to enhance it up to 65mm to be able to enter 3 r'22's teledyne sensors.
I used a sharp boring tool but did not obtained a nice surface state as you can see watching the picture.
how could I get a better result
my cutting parameter are , speed : 300 rpm no cutting oil no cooling liquid.
is there a better method of getting a nice surface state off a pressure pvc fitting.
regards
jean mi |