Thread: Cells....
View Single Post
Old 17th December 2007, 20:42   #3 (permalink)
Janos
"Two Sheds"
 
Janos's Avatar

Current Rebreather/s:
Classic Kiss

Other Rebreather/s:
Classic Kiss
 
Join Date: Feb 2005
Location: East Surrey
Posts: 601
Janos is a name known to allJanos is a name known to allJanos is a name known to allJanos is a name known to allJanos is a name known to allJanos is a name known to allJanos is a name known to allJanos is a name known to allJanos is a name known to allJanos is a name known to allJanos is a name known to all
Re: Cells....

Quote: (Originally Posted by netmage) View Original Post
Was reading through the manual and came across the bit about cell ranges being from 0.8 to 1.3 mV and decided to do some tinkering.....

Previous owner installed a new cell when I took possesion and labelled install dates on the cells...
#1 - 2/07 - s/n 60844871
#2 - 12/07 - s/n 71120735
#3 - 2/07 - s/n 60844872
-------------------
When I pull up System Monitor (from the secondary) I see the following:
.22 9.7
.22 12.7
.20 8.7

Unit was calibrated a bit over a week ago over at Padipro's...

Is this low mV output and inconsistency in relation to the other cells an indication that that third cell is on its last legs...?

Should I recaibrate and pull values again...?

Training is the end of next month; how many spares should I have on hand...

-Tim
If it's in range don't worry about it. Each cell has a different voltage. You could have three cells at 9mV, or three at 12mV, or a mixture of both and somewhere in between.

Don't worry about it.

Janos
__________________
You can lead a horse to water but you can't climb a ladder with a large bell in both hands - Vic Reeves
www.hellfins.com/shed
(Offline)
 
Reply With Quote