| Re: Prism Topaz - Analog Secondary & Cell Sensors
Walk over to your unit, switch the analogue secondary to set point and switch the electronics on. You will notice that the needle moves from reading zero to whatever setpoint is. Now turn the electronics off and you will notice the needle returns to zero. Now bearing in mind that the needle must not be resting at zero if it is to be protected it must not be at zero so...
why would you put it on set point to protect it?
Up until this point I have thought that others criticizing your posts have been unfairly harsh, but I am starting to think you shouldn't be on CCR. By all means question, but you haven't paid attention to what others have written. It does not appear that you have understood the most basic instructions from your course or that you have the capacity for reasoned thought.
If you cannot grasp this most fundamental of concepts, how are you going to survive in an emergency situation WHEN something goes wrong.
No one wants any more fatalities.
Ben. |