divetheworld

We have tried to solve as many problems as possible when incorporating the Shearwater controller into the "Deep Pursuit". It was never meant to be an "all things to all men" product, simply a more reliable one.The "Shearwater" rebreather controller has emerged as one of the most intuitive and reliable controllers ever built. A fact we are proud to state as the "Pursuit" electronics package is the cornerstone of this upgrade.

Custom variants will be available, including a secondary display with full deco.
Remember, our HUD is a completely independant secondary. The addition of a display handset or deco handset would give triple redundancy.

Pricing will be under £2k and production will start as soon as formal testing has been completed. We expect to be taking orders at the NEC where it will be on show for you to see and play with, along side the Cell Checker.

Dont forget to check out the manual we have written at the bottom of this page for the Pursuit. The manual will be subject to changes following the completion of the testing.


Features

� Depth, time and oxygen sensor display
� 180degree rotating display
� Buhlmann algorithm with user configurable gradient factor conservatism
� External battery compartment
� Automatic switch-on by depth and/or pressure
� Automatic ambient light sensing LCD illumination
� High/Low PO2 and Deco violation alarm
� Fully independent HUD with three cell real time and simultaneous PO2 indication
� Imperial and metric displays
� Two set points, each of which can be set between .4 and 1.4
� User definable oxygen content of supply gas
� A menu system that adapts to diving status
� Automatic turn off after 30 minutes on the surface
� Set point is controlled and sensors displayed while in menus
� Any combination of oxygen, nitrogen, and helium
� Open and closed circuit gas list, switchable during a dive
� 5 CC and 5 OC user selectable gases
� Gases can be enabled/disabled, changed and added during a dive
� CNS tracking
� No lockout
� Automatic setpoint switching (configurable)
� Backup battery to allow battery change without losing tissues
� Adaptive PID setpoint control
� Total control calibration system
� Automatic diluent flush display calculation
� Millivolt display for all cells "on demand"
� Easy oxygen cell replacement
� Robust, single billet manufactured head
� User serviceable wiring loom
� Critical components protected in the event of a flooding
� "Single moving part" failure tolerant and user serviceable solenoid
� Solenoid failure detection system
� Built in 4th cell holder
� Completely independent power supplies for the Controller, HUD and solenoid
� End user updateable firmware via infra red interface

Damn, is that all!

Enquiries to pursuit@grpservices.com
Download the manual here -> GRP Services

__________________