Where do you mount the filter? After the ball valve or between just before the snubber?
I suppose if there is going to be any junk it will probably come from the ball vallve getting slightly worn out or some crud enterin through the o2 feed side.
Or it could alternatively travel from the o2 injection valve side. So maybe right before the snubber is best. But what if one where to install a one way valve. That way if you have to shut your o2 for some reason moisture will not travel from the loop to the valve and snubber. What part would that be now...
Teoman
Quote: (Originally Posted by
Dave Sutton)
YES!!
I was just going to reply to your PM, and found this. That's the correct part number. I just ordered a few bags of them today.
The filters I use are Part Number 98355K831
These are 40 micron in-line, which is larger than what Gordon used on the original KISS but which are plenty fine for our use. LOTS smaller than the orifice size. LOTS smaller than the other filter suggested, and lots less expensive. Works great.
Sorry for late reply to your PM's, I've just been away from my catalog.
Dave